24 Loading Print Media
www.dell.com | support.dell.com
• Load a sheet of card stock
with the side to be printed on facing up
, short edge first, from
the center of the tray.
NOTE: Do not print on media smaller than 3.0 in. (76 mm) wide or 5.0 in. (127 mm) long.
• Load a letterhead in the tray
with the design face up
,
top edge toward the printer
.
NOTE: Before you load letterhead, verify that the ink on the paper is dry. During the fusing
process, wet ink can come off preprinted paper.
1100-OM_EN.book Page 24 Friday, May 20, 2005 3:14 PM
To Next Page
Loading...
