Replacing the status-light board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Place the status-light board in the slot on the palm-rest assembly and snap it into
place.
2 Slide the status-light board cable under the speaker cable.
3 Connect the status-light board cable to the system board.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
59
To Next Page
Loading...
