Menu item Description
Network Buffer
Auto
3K to <maximum size allowed>
Sets the size of the network input buffer
Notes:
• Auto is the factory default setting.
• The value can be changed in 1K increments.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
• To increase the maximum size range for the Network Buffer, disable or reduce
the size of the parallel and USB buffers.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
Std Network Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
NetWare
Net <x> Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
Apple Talk
NetWare
For descriptions and settings of the network setup menus, see the following:
• “Reports menu (under the Network/Ports menu)” on page 166
• “Network Card menu” on page 167
• “TCP/IP menu” on page 167
• “IPv6 menu” on page 169
• “Wireless menu” on page 169
• “AppleTalk menu” on page 170
• “NetWare menu” on page 170
Note: The Wireless menu appears only when the printer is connected to a wireless
network.
Reports menu (under the Network/Ports menu)
The Reports menu item is available from the Network/Ports menu:
Understanding printer menus
166
To Next Page
Loading...
Need help?
General
