Menu item Description
Allow Background Removal
On
Off
Specifies whether image background removal is allowed during
copy, fax, e-mail, FTP, or scan to USB
Note: On is the factory default setting. The background of the
image will be removed.
Allow Custom Job Scans
On
Off
Lets you scan multiple jobs to one file
Notes:
• A printer hard disk must be installed in the printer and
operating properly for this menu item to be available.
• On is the factory default setting. If On is selected, the Allow
Custom Job Scans setting can be enabled for specific jobs.
Scanner Jam Recovery
Job level
Page level
Specifies how a scanned job should be reloaded if a paper jam
occurs in the ADF
Notes:
• If Job level is selected, the entire job must be rescanned if any
pages jam.
• If Page level is selected, rescan from the jammed page
forward.
Web Page Refresh Rate
30–300
Specifies the number of seconds between Embedded Web Server
refreshes
Note: 120 seconds is the factory default setting.
Contact Name
Specifies a contact name for the printer
Location
Specifies the location of the printer
Note: The location will be stored on the Embedded Web Server.
Alarms
Alarm Control
Cartridge Alarm
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Notes:
• Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
• Off is the factory default setting for Toner Alarm. Off means
no alarm will sound.
Timeouts
Standby Mode
Disabled
2–240
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Understanding printer menus
184
To Next Page
Loading...
Need help?
General
