Using Your Projector 31
4 Volume Control Allows you to increase or decrease the volume.
5 Up / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+/-30 degrees).
6 Right /
Auto Adjust
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to synchronize the projector to the input
source.
NOTE: Auto Adjust does not operate if the
on-screen display (OSD) is displayed.
7 IR Receiver Point the remote control towards the IR receiver
and press a button.
8 Down / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+/-30 degrees).
9 Menu Press to activate the OSD. Use the directional
keys and the Menu button to navigate through
the OSD.
10 Left / Source Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to toggle through Analog RGB, Composite,
Component (YPbPr via VGA), HDMI, and
S-Video sources when multiple sources are
connected to the projector.
11 Enter Press to confirm the selection item.
12 Brightness and
Contrast Control
Allows you to adjust the brightness and contrast
values.
To Next Page
Loading...
