Table 11. System setup options—Security menu
Security
Unlock Setup Status Displays if the setup status is
unlocked.
Admin Password Status Displays if the administrator password
is clear or set.
Default: Not set
System Password Status Displays if the system password is
clear or set.
Default: Not set
HDD Password Status Displays if the HDD password is clear
or set.
Default: Not set
Admin Password Enables you to set the administrator
password. The administrator password
controls access to the system setup
utility.
System Password Enables you to set the system
password. The system password
controls access to the computer at
boot.
HDD password Enables you to set, change or delete
the hard-disk drive password.
Password Change Enables you to permit or deny system
password or HDD password changes.
Default: Permitted
Computrace Enable or disable the BIOS module
interface of the optional Computrace
Service from Absolute Software.
Default: Activate
Firmware TPM Enables you to enable or disable the
rmware TPM function.
Default: Enabled
PPI Bypass for Clear Command Enables you to control the TPM
Physical Presence Interface (PPI).
130
To Next Page
Loading...
