About this task
NOTE: If the battery is disconnected from system board, there is delay during computer boot as the computer undergoes
Real Time Clock (RTC) reset.
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Align and place the battery into the slot on the palmrest assembly.
2. Adhere the adhesive tape to secure the battery to the palmrest assembly.
3. Replace the three screws (M2x3) to secure the battery into the palmrest assembly.
4. Route the battery cable through the routing channels in the palmrest assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
24
Removing and installing components
To Next Page
Loading...
