Steps
1. Insert the keyboard FPC cable from the gap in the palmrest assembly.
2. Align the keyboard on the palmrest assembly. Gently press the keyboard and snap it into place.
3. Connect the keyboard FPC cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card for 4G LTE enabled systems.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
28
Removing and installing components
To Next Page
Loading...
