Steps
1. Connect the display cable to the connector and close the latch.
2. Adhere the rubber spacer covering the display cable.
3. Adhere the conductive tape covering the display cable connector.
4. Adhere the clear tape to cover the display cable connector.
5. Insert the display panel tabs into the slots on the display cover.
6. Replace the four (M2x3) screws to secure the display panel to the display assembly.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the WWAN card for 4G LTE enabled systems.
4. Install the base cover.
5. Follow the procedure in after working inside your computer.
Camera
Removing the camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card for 4G LTE enabled systems.
4. Remove the display assembly.
5. Remove the display bezel.
50
Removing and installing components
To Next Page
Loading...
