About this task
The following images indicate the location of the camera and provide a visual representation of the removal procedure.
Steps
1. Disconnect the camera cable from its connector on the camera.
2. Peel the conductive tape that secures the camera in place.
3. Use a plastic scribe to carefully pry the camera starting from the top side of the camera module.
4. Lift and remove the camera module from the display back cover.
Installing the camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the camera and provides a visual representation of the installation procedure.
Removing and installing components
51
To Next Page
Loading...
