Steps
1. Connect the battery cable to the connector on the system board.
2. Align and place the base cover on the computer chassis, and snap the base cover latches into place.
3. Tighten the nine captive screws to secure the base cover to the computer chassis.
Next steps
ā Follow the procedure in after working inside your computer.
SIM card
Removing the SIM card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
About this task
NOTE: The following steps are applicable only for 4G LTE enabled systems.
NOTE: The following steps are not applicable for systems configured with pre-installed SIM card.
WARNING: Do not press on the SIM card connector.
The following image indicates the location of the SIM card and provides a visual representation of the removal procedure.
Removing and installing components
17
To Next Page
Loading...
