Display back cover
Removing the display back-cover and antenna assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card for 4G LTE enabled systems.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display panel.
7. Remove the display hinges.
8. Remove the camera.
9. Remove the Display cable.
About this task
NOTE: The display back cover and antenna assembly cannot be further disassembled once all of the pre-removal parts
procedures are completed. If the WLAN (For WiFi enabled systems) and/or WWAN (For 4G LTE enabled systems) antenna
cables are malfunctioning and need to be replaced, replace the entire display back cover and antenna assembly.
The following images indicate the location of the display back-cover and antenna assembly and provide a visual representation
of the removal procedure.
Steps
After performing the preceding steps, you are left with the display back cover.
Installing the display back-cover and antenna assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
57
To Next Page
Loading...
