NOTE: While installing the speakers onto the palmrest assembly, the speaker cables must be routed correctly into
the routing channels at the bottom of the palmrest assembly. If not routed properly, the speaker cables may become
pinched and damaged when replacing the base cover.
3. Connect the speaker cable to the connector on the system board.
4. Adhere the transparent tape to secure the speaker cable in place.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
Display bezel
Removing the display bezel
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card for 4G LTE enabled systems.
4. Remove the display assembly.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the removal procedure.
42
Removing and installing components
To Next Page
Loading...
