Steps
1. Lower the display hinges on the display assembly.
2. Replace the four (M2.5x2.5) and two (M2x3) screws to secure the left and right display hinges to the display back cover.
3. Adhere the conductive tape to secure the display cable in place at the left display hinge.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WWAN card for 4G LTE enabled systems.
5. Install the base cover.
6. Follow the procedure in after working inside your computer.
54
Removing and installing components
To Next Page
Loading...
