WWAN card
Removing the WWAN card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: The following steps are applicable only for systems that are shipped with a WWAN card.
The following image indicates the location of the WWAN card and provides a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x3) that secures the WWAN-card bracket to the WWAN card on the system board.
2. Lift and remove the WWAN-card bracket from the WWAN card.
3. Disconnect the WWAN antenna cables from the connectors on the WWAN card.
4. Slide and remove the WWAN card from the WWAN-card slot on the system board.
18
Removing and installing components
To Next Page
Loading...
