Installing the WWAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: The following steps are applicable only for systems that are shipped with a WWAN card.
The following image indicates the location of the WWAN card and provides a visual representation of the installation procedure.
Steps
1. Align the notch on the WWAN card with the tab on the WWAN-card slot.
2. Slide the WWAN card at an angle into the WWAN-card slot.
3. Connect the WWAN antenna cables to the connectors on the WWAN card.
4. Align and place the WWAN-card bracket on the system board.
5. Replace the screw (M2x3) to secure the WWAN card and WWAN-card bracket to the system board.
NOTE:
For instructions on how to find your computer's International Mobile Station Equipment Identity (IMEI) number,
see the knowledge base article 000143678 at https://www.dell.com/support/.
Next steps
1. Install the base cover.
Removing and installing components
19
To Next Page
Loading...
