Installing the display back-cover and antenna assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display back-cover and antenna assembly.
Steps
Place the display back-cover and antenna assembly on a flat surface and perform the postrequisites to install the display
back-cover and antenna assembly.
Next steps
1. Install the display cable.
2. Install the display hinges.
3. Install the camera.
4. Install the display panel.
5. Install the display bezel.
6. Install the display assembly.
7. Install the WWAN card for systems enabled with 4G LTE.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
62
Removing and installing components
To Next Page
Loading...
