Dell D2421H - Setting Up the Monitor; Connecting the Stand

24 │ Setting Up the Monitor
Setting Up the Monitor
Connecting the stand
NOTE: The stand is not installed at the factory when shipped. (D2421H/D2721H)
NOTE: The stand is installed at the factory when shipped. (D2421DS)
NOTE: The graphics are used for the purpose of illustration only. Appearance on
the computer may vary.
NOTE: The following instructions are applicable only for attaching the stand that
was shipped with your monitor. If you are attaching a stand that you purchased
from any other source, follow the set up instructions that were included with the
stand.
To attach the monitor stand:
D2421H
1. Assemble the stand riser to stand base.
a. Place the monitor stand base on a stable table top.
b. Slide the monitor stand body in the downward direction into the stand base
until it clicks into place.
2. Attach the stand assembly to the monitor:
a. Place the monitor on a soft cloth or cushion near the edge of desk.
b. Align the stand assembly bracket to the monitor groove.
c. Insert the bracket towards monitor until it locks in place.