Figure 54. Removing the external cooling fan
Next steps
1 Follow the procedure listed in After working inside your system.
2 Install the air shroud.
Related link
Removing the air shroud
Installing the external cooling fan
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Route the external cooling fan power cable into the system through the slot at the back of the chassis.
2 Align and insert the lower and upper hooks on the external cooling fan into the corresponding slots at the back of the chassis.
3 Use the four screws to secure the external cooling fan to the chassis.
4 Connect the external cooling fan power cable to the FAN2 connector on the system board.
Installation and Service Manual
Installing and removing system components
105
To Next Page
Loading...
