4 Using the key lock the bezel.
Figure 14. Installing the front bezel
System feet
The system feet provide stability to the system in the tower mode.
Removing the system feet
Prerequisites
NOTE
: It is recommended that you remove the system feet only when you are converting the system from the tower mode to the
rack mode, or when you are replacing the system feet with the wheel assembly.
1 Follow the safety guidelines listed in Safety instructions.
2 Place the system on its side on a at, stable surface.
3 Rotate the system feet inward.
Step
Using the Phillips #2 screwdriver, remove the screw that secures the foot to the base of the system.
a Repeat the above step for the 3 remaining feet.
62
Installation and Service Manual
Installing and removing system components
To Next Page
Loading...
