Figure 31. Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
Next step
Install the 3.5 inch drive carrier or install the 3.5 inch drive adapter into the 3.5 inch drive carrier.
Related link
Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Install the 2.5 inch drive into the 3.5 inch drive adapter.
Steps
1 Insert the 3.5 inch drive adapter into the 3.5 inch drive carrier with the connector end of the drive toward the back of the 3.5 inch
drive carrier.
2 Align the screw holes on the 3.5 inch drive adapter with the holes on the 3.5 inch drive carrier.
3 Using the Phillips #1 screwdriver, secure the 3.5 inch drive adapter to the 3.5 inch carrier.
Installation and Service Manual
Installing and removing system components
79
To Next Page
Loading...
