2 Turn o the system, including any attached peripherals.
3 Disconnect the system from the electrical outlet and disconnect the peripherals.
4 If installed, remove the optional bezel. For more information, see the Removing the optional front bezel section.
5 If installed, remove the front bezel.
Steps
1 Rotate the latch release lock counter clockwise to the unlocked position.
2 Lift the latch toward the back of the system.
The system cover slides back and the tabs on the system cover disengage from the slots on the chassis.
NOTE: The position of the latch may vary depending on the conguration of your system.
3 Hold the cover on both sides, and lift the cover away from the system.
Figure 9. Removing and installing the system cover
1
latch release lock 2 latch
3 system cover
Next step
1 Install the system cover.
Installing the system cover
Prerequisites
1 Follow the safety guidelines listed in the safety instructions section.
2 Ensure that all internal cables are connected and placed out of the way and no tools or extra parts are left inside the system.
Installing and removing system components
47
To Next Page
Loading...
