Dell EMC NX430 System - Installing the Cooling Fan Blank

Figure 19. Removing and installing a cooling fan blank
1
cooling fan blank (2) 2 release tab (2)
3 cooling fan bracket 4 tab
Next steps
1 Install the cooling fan.
2 Follow the procedure listed in the After working inside your system section.
Installing the cooling fan blank
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The procedure for removing each cooling fan blank is identical.
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Lower the cooling fan blank into the cooling fan bracket.
2 Insert the tabs on the cooling fan blanks into the slots on the cooling fan bracket.
3 Press the cooling fan blank until it clicks into place.
Next step
Follow the procedure listed in the After working inside your system section.
Installing and removing system components
65