Removing the rear VGA port
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove expansion card riser 3.
Steps
1. Disconnect the VGA port cable from the video connector on the rear I/O board and open the latch on the expansion card
riser.
2. Slide the VGA port out of the expansion card riser.
Figure 116. Removing the VGA port
3. If the VGA module is not going to be replaced, install a filler bracket and close the card retention latch.
Figure 117. Installing the filler bracket
Installing and removing system components
131
To Next Page
Loading...
