Next steps
1. Replace the rear VGA module or install the riser blank.
Installing the rear VGA port
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove expansion card riser 3.
Steps
1. If installed, remove the filler bracket from the expansion card riser (Riser 3).
NOTE: For more information about how to remove the filler bracket, see the Removing the expansion card from the
expansion card riser topic.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Figure 118. Removing the filler bracket
2. Slide the VGA port into the expansion card riser.
3. Close the expansion card retention latch.
4. Connect the VGA cable to the connector on the rear I/O board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
132 Installing and removing system components
To Next Page
Loading...
