6. Disconnect the paddle card cables from the drive backplane.
Steps
1. Holding the edges, align the hole on the paddle cards with the guides on the system board.
2. Lower the paddle cards into place and press until the paddle card connector is fully seated on the system board connector.
Figure 167. Installing the R1 paddle card
Figure 168. Installing the R3 paddle card
Next steps
1. Connect the paddle card cables to the drive backplane.
2. Insert the paddle card cable into the side wall bracket.
3. Install cooling fan cage assembly.
4. Install the air shroud or install the GPU air shroud.
5. Follow the procedure listed in After working inside your system.
Installing and removing system components
169
To Next Page
Loading...
