3. Slide the wireless card into the M.2 card slot on the system board.
4. Place the wireless-card bracket on the wireless card.
5. Replace the screw (M2x3) that secures the wireless card and wireless-card bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
28
Removing and installing components
To Next Page
Loading...
