Steps
1. Using the alignment posts, place the left speaker and the right speaker on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.
4. Place the antenna cables back into place and adhere the tapes that secure them to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the right fan.
3. Install the wireless card.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the heat sink.
7. Remove the power-adapter port.
8. Remove the I/O board.
9. Remove the left fan and the right fan.
Removing and installing components
51
To Next Page
Loading...
