Figure 97. Installing the system board (for computers shipped with a plastic chassis)
7. For computers shipped with an aluminum chassis, replace the two screws (M2x4) to secure the USB Type-C port bracket to
the system board.
Figure 98. Installing the system board (for computers shipped with an aluminum chassis)
8. Connect the following cables to the connectors the system board:
a. I/O-board cable (IOBD1)
b. eDP cable (LCD)
c. Power-adapter port cable (DCIN1)
d. Keyboard-backlight cable (KBBL1)
NOTE: This step applies only to computers shipped with a keyboard backlight installed.
e. Keyboard cable (KB1)
f. Touchpad cable (TP1)
g. Speaker cable (SPK1)
116
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
