Steps
1. Place the heat sink on the system board.
2. Tighten the seven captive screws that secure the heat sink to the system board.
NOTE: Tighten the captive screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4> 5 > 6 > 7].
NOTE: The number of screws varies depending on the configuration ordered.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in After working inside your computer.
Power-button board
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the I/O board.
6. Remove the display assembly.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Removing and installing components
47
To Next Page
Loading...
