Steps
After performing the pre-requisites, you are left with the palm-rest and keyboard assembly.
Installing the palmrest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the palmrest and keyboard assembly and provides a visual representation of the
installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the power button.
3. Install the power-adapter port.
4. Install the display assembly.
5. Install the touchpad.
6. Install the hard drive assembly.
7. Install the I/O board.
8. Install the heat sink.
9. Install the fan.
10. Install the speakers.
11. Install the wireless card.
12. Install the memory modules.
13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive (whichever applicable).
Removing and installing components
81
To Next Page
Loading...
