Steps
1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
2. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
3. Replace the four (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
4. Route the WLAN antenna cables through the routing guides on the palm-rest and keyboard assembly.
5. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE: Ensure to route the speaker cable over the WLAN antenna cables.
6. Connect the display cable to the connector on the system board.
Next steps
1. Install the wireless card.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
Display bezel
Removing the display bezel
Prerequisites
NOTE: This procedure is applicable for systems with plastic chassis.
Removing and installing components 55
To Next Page
Loading...
