NOTE: Start prying the camera module in a sequential order 1>2>3 as indicated on the display back cover.
3. Lift the camera module from the display assembly.
Installing the camera module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the camera module and provide a visual representation of the installation
procedure.
Steps
1. Adhere the camera module in its slot on the display assembly.
2. Connect the camera cable to the camera module.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display hinge caps.
5. Install the display assembly.
6. Install the wireless card.
7. Install the base cover.
8. Install the SD card.
9. Follow the procedure in After working inside your computer.
eDP cable
Removing the eDP cable
Prerequisites
NOTE: The eDP cable removal procedure is applicable only for systems with plastic chassis.
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
9. Remove the display panel.
About this task
The following image indicates the location of the eDP cable and provides a visual representation of the removal procedure.
68
Removing and installing components
To Next Page
Loading...
