4. Install the three (M2.5x3.8) screws to secure the hinge to the display panel and back cover.
Next steps
1. Install the display bezel.
2. Install the hinge caps.
3. Install the display assembly.
4. Install the wireless card.
5. Install the base cover.
6. Install the SD card.
7. Follow the procedure in After working inside your computer.
Camera module
Removing the camera module
Prerequisites
NOTE: This procedure is applicable for systems with a plastic chassis only.
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
9. Remove the display panel.
About this task
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
Removing and installing components
67
To Next Page
Loading...
