Display cover and antenna assembly
Replacement of the display cover and antenna assembly
Prerequisites
NOTE: This procedure is applicable for systems shipped with a plastic chassis only.
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the hinge caps.
7. Remove the display bezel.
8. Remove the hinges.
9. Remove the display panel.
10. Remove the camera module.
11. Remove the eDP cable.
NOTE: The display cover and antenna assembly cannot be further disassembled. If the WLAN antennas are malfunctioning
and needs replacement, replace the entire display cover and antenna assembly.
About this task
The following image indicates the location of the display cover and antenna assembly and provides a visual representation of the
removal procedure.
Steps
After performing the pre-requisites, you are left with the display cover and antenna assembly.
Removing and installing components
71
To Next Page
Loading...
