h. eDP cable
6. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
7. Replace the two (M2.5x5) screws to secure it to the palm-rest assembly.
Next steps
1. Install the display assembly.
2. Install the heat sink.
3. Install the fan.
4. Install the wireless card.
5. Install the memory modules.
6. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive (whichever applicable).
7. Install the 3-cell battery or 4-cell battery (whichever applicable).
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the display assembly.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
78
Removing and installing components
To Next Page
Loading...
