GUID-2DF70EB1-9D26-4051-8B7C-FB14A89925D8
Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
GUID-20513DC8-46A2-43D0-9037-C0681DDE3299
Procedure
1 Align the screw holes on the display assembly with the screw holes on the
computer base.
2 Replace the four screws (M2x5) that secure the display assembly to the
computer base.
3 Slide the display cable and antenna cables through the slot on the computer
base.
4 Close the display and turn the computer over.
5 Route the display cable and antenna cables through the routing guides on the
computer base.
6 Connect the antenna cables to the wireless card.
7 Connect the display cable to the system board.
8 Close the display and turn the computer over.
GUID-54B4E1CC-911F-4017-B455-13135928F7F6
Post-requisites
1 Replace the fans.
2 Replace the palm-rest assembly.
3 Replace the keyboard.
4 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
87
To Next Page
Loading...
