Replacing the I/O board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Slide the I/O-board cable into its connector on the I/O board and close the
latch to secure the cable.
2 Adhere the tape that secures the I/O-board cable to the I/O board.
3 Turn the I/O board over and align the screw hole on the I/O board with the
screw hole on the palm-rest assembly.
4 Replace the screw that secures the I/O board to the palm-rest assembly.
Post-requisites
1 Follow the procedure from step 3 to step 7 in “Replacing the base cover”.
2 Replace the keyboard.
3 Follow the procedure from step 4 to step 5 in “Replacing the optical drive”.
4 Replace the battery.
22
Replacing the I/O board 53
To Next Page
Loading...
