Dell Inspiron 15 - 32 Replacing the Touch Pad; Procedure; Post-Requisites

Replacing the touch pad
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Place the touch pad on the palm-rest assembly.
2 Slide the tabs on the touch-pad bracket into the slots on the palm-rest
assembly.
3 Slide the touch-pad cable into the connector on the touch pad and close the
latch to secure the cable.
4 Align the screw holes on the touch-pad bracket with the screw holes on the
palm-rest assembly.
5 Replace the screws that secure the touch-pad bracket to the palm-rest
assembly.
6 Adhere the tape over the touch-pad bracket.
Post-requisites
1 Replace the system board.
2 Replace the heat-sink assembly.
3 Replace the I\O board.
4 Replace the wireless card.
5 Replace the memory module.
32
Replacing the touch pad 76