Dell Inspiron 15 - 36 Replacing the Display Assembly; Procedure; Post-Requisites

Replacing the display assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Place the display assembly on the palm-rest assembly.
2 Close the display hinges and align the screw holes on the display hinges with
the screw holes on the palm-rest assembly.
3 Replace the screws that secure the display hinges to the palm-rest assembly.
4 Route the display cable through its routing guides on the palm-rest assembly.
5 Route the antenna cables through its routing guides on the palm-rest assembly.
6 Close the display and turn the computer over.
Post-requisites
1 Replace the system board.
2 Replace the heat-sink assembly.
3 Replace the I/O board.
4 Replace the wireless card.
5 Replace the memory module.
6 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
7 Follow the procedure from step 3 to step 7 in “Replacing the base cover”.
36
Replacing the display assembly 89