Steps
1. Place the I/O cover on the display-assembly base.
2. Align the screw holes on the I/O cover with the screw holes on the display-assembly base.
3. Replace the two screws (M3x5) that secure the I/O cover to the display-assembly base and snap the I/O cover back into
place.
Next steps
1. Install the back cover.
2. Install the stand.
3. Follow the procedure in After working inside your computer.
Stand hinges
Removing the stand hinges
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. See the procedure for removing the stand and installing the stand.
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the removal procedure.
Figure 24. Removing the stand hinges
Steps
1. Remove the 10 screws (M3x4.5) that secure the right and left stand hinges to the display-assembly base.
48
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
