Dell Inspiron 24 5430 All-in-One - Fan; Removing the Fan

About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
installation procedure.
Figure 35. Installing the camera
Steps
1. Slide and place the retractable-camera assembly on the display-assembly base.
2. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
3. Adhere the tape that secures the camera cable to the display-assembly base.
4. Connect the camera cable to its connector (WEBCAM) on the system board.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
Removing and installing Customer Replaceable Units (CRUs)
59