NOTE: The etchings on the system-board shield do not represent the components that are supported by this computer.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the installation
procedure.
Figure 27. Installing the system-board shield
Steps
1. Align the screw holes on the system-board shield with the slots on the display-assembly base.
2. Place the system-board shield on the display-assembly base.
3. Replace the four screws (M3x5) that secure the system-board shield to the display-assembly base.
Next steps
1. Install the I/O cover.
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
51
To Next Page
Loading...
