2. Lift the stand hinges off the display-assembly base.
Installing the stand hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. See the procedure for removing the stand and installing the stand.
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the installation procedure.
Figure 25. Installing the stand hinges
Steps
1. Align the screw holes on the stand hinges with the screw holes on the display-assembly base.
2. Replace the 10 screws (M3x4.5) that secure the stand hinges to the display-assembly base.
Next steps
1. Install the I/O cover.
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
49
To Next Page
Loading...
