9. Install the media-card reader.
10. Install the system-board shield.
11. Install the I/O cover.
12. Install the back cover.
13. Install the stand.
14. Follow the procedure in After working inside your computer.
Display panel
Removing the display panel
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
6. Remove the media-card reader.
7. Remove the wireless card.
8. Remove the M.2 2230 solid-state drive.
9. Remove the integrated heat sink or discrete heat sink, as applicable.
10. Remove the system board.
About this task
The following image indicates the location of the display panel and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
87
To Next Page
Loading...
