Retractable-camera assembly
Removing the retractable-camera assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
removal procedure.
Figure 34. Removing the camera
Steps
1. Disconnect the camera cable from its connector (WEBCAM) on the system board.
2. Peel the tape that secures the camera cable to the display-assembly base.
3. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
4. Remove the retractable-camera assembly from the display-assembly base.
Installing the retractable-camera assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
58
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
