Middle frame assembly
Removing the middle-frame assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
6. Remove the media-card reader.
7. Remove the fan.
8. Remove the memory module.
9. Remove the wireless card.
10. Remove the retractable-camera assembly.
11. Remove the M.2 2230 solid-state drive.
12. Remove the integrated heat sink or discrete heat sink, as applicable.
13. Remove the system board.
14. Remove the speakers.
15. Remove the microphones.
16. Remove the stand hinges.
17. Remove the power-button board with USB.
18. Remove the display panel.
About this task
The following image indicates the location of the middle-frame assembly and provides a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
91
To Next Page
Loading...
