Figure 57. Installing the microphones
Steps
1. Align and place the microphone module into the slot on the display-assembly base.
2. Replace the four screws (M2X3.5) that secure the microphone module to the display-assembly base.
3. Route the microphone cable through the routing guides on the display-assembly base.
4. Adhere the tape that secures the microphone cable to the display-assembly base.
Next steps
1. Install the system board.
2. Install the integrated heat sink or, discrete heat sink, as applicable.
3. Install the M.2 2230 solid-state drive.
4. Install the wireless card.
5. Install the memory module.
6. Install the media-card reader.
7. Install the system-board shield.
8. Install the I/O cover.
9. Install the back cover.
10. Install the stand.
11. Follow the procedure in After working inside your computer.
84
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
