Table 28. System setup options—Overview menu(continued)
Overview
Memory Available Displays the total computer memory available.
Memory Speed Displays the memory speed.
Memory Channel Mode Displays single or dual channel mode.
Memory Technology Displays the technology that is used for the memory.
DIMM 1 size Displays the total size of the DIMM 1 memory module.
DIMM 2 size Displays the total size of the DIMM 2 memory module.
Devices Information
Panel Type Displays the Panel Type of the computer.
Video Controller Displays the video controller type of the computer.
Video Memory Displays the video memory information of the computer.
Wi-Fi Device Displays the wireless device information of the computer.
Native Resolution Displays the native resolution of the computer.
Video BIOS Version Displays the video BIOS version of the computer.
Audio Controller Displays the audio controller information of the computer.
Bluetooth Device Displays the Bluetooth device information of the computer.
LOC MAC Address Displays the MAC address of the video pass-through.
dGPU Video Controller Displays the dGPU video controller type of the computer.
Table 29. System setup options—Boot Configuration menu
Boot Configuration
Boot Sequence
Boot Mode: UEFI only Displays the boot mode of the computer.
Boot Sequence Displays the boot sequence.
By default, the UEFI RST P0221 NVMe Phison 1024GB H5FGYSAPT36F0036
option is selected.
By default, the ONBOARD NIC (IPV4) option is selected.
By default, the ONBOARD NIC (IPV6) option is selected.
By default, the UEFI HTTPs (MAC:20881078A4CD) option is selected.
Secure Boot Secure Boot is a method of guaranteeing the integrity of the boot path by
performing additional validation of the operating system and PCI add-in cards.
The computer stops booting to the operating system when a component is not
authenticated during the boot process. Secure Boot can be enabled in BIOS setup
or using management interfaces like Dell Command|Configure, but can only be
disabled from BIOS setup.
Enable Secure Boot Enables the computer to boot using only validated boot software.
By default, the Enable Secure Boot option is disabled.
For additional security, Dell Technologies recommends keeping the Secure Boot
option enabled to ensure that the UEFI firmware validates the operating system
during the boot process.
NOTE: For Secure Boot to be enabled, the computer is required to be in
UEFI boot mode and the Enable Legacy Option ROMs option is required to be
turned off.
BIOS Setup 97
To Next Page
Loading...
