174 Appendix
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3
Locate the 3-pin password connector (PSWD) on the system board.
4
Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5
Wait for approximately five seconds to clear the password.
6
Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3 to enable the password feature.
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 160).
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
8
Connect your computer and devices to electrical outlets, and turn them on.
book.book Page 174 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
